Unknown email address. Check again or try your username.

Jim Gleeson - Victaulic

Questions:

Votes	Status	Answer
0 votes	approved	We have two different styles to “keep Revit happy”. The software expects certain types of fittings t... posted October 14, 2020 5:58 pm in reply to [RESOLVED] What does "_MP" mean on the coupling families?
0 votes	approved	The “cheese wedges” are pieces of geometry pointing to the work points of each elbow and tee. They e... posted October 14, 2020 5:57 pm in reply to [RESOLVED] Cheese Wedge / Mohawk visibility on elbows and tees
0 votes	approved	a. Vic_Field Material can be used to identify components that will be installed onsite rather than p... posted October 13, 2020 7:53 pm in reply to [RESOLVED] Vic_Field Material, Vic_Field Cut, and Vic_Do Not Schedule parameters
0 votes	approved	This is a restriction within the native Revit software. Utilizing routing preferences, Revit is tryi... posted October 13, 2020 7:52 pm in reply to [RESOLVED] Placing Mechanical Tees and Taps
0 votes	approved	Multiple “typical” spools are possible, but not advised. Any change to one of the “typical” spools r... posted October 13, 2020 7:50 pm in reply to [RESOLVED] Typical (Identical) Assemblies
0 votes	approved	There is a section of the Toolbar Settings called Delete Pipe Settings that enable the user to assoc... posted October 13, 2020 7:44 pm in reply to [RESOLVED] Delete Pipe / Any Connect Coupling Placement